Whether you want to add a product to your bill, identify a client by scanning his card or add a luncheon voucher to the means of payment, barcodes are a huge time saver and allow you increase the cshing of your clients.
Info : the barcode readers must be configured with a tab at the end of the sequence and not a carriage return.
Supported Bluetooth barcode readers
- Inateck – BCST-10 Bluetooth barcode reader
- See the list of the supported Bluetooth barcode readers
Not working with the Samsung tablets using the Android 5.1.1 version)
Barcode readers setup
· Necessary equipment :
- The Bluetooth barcode reader
- The setup page available in the appendix
Info : the range of a Bluetooth barcode reader is limited to 10 metres maximum.
· Connections :
- Make sure the barcode reader battery is recharged, otherwise charge it
- Turn on the barcode reader by pressing the trigger until you hear a long beep
- Scan the barcode reader configuration sheet available in the appendix
· Pairing the barcode reader with Bluetooth :
Careful : not working with the Samsung tablets using the Android 4.1.1 version !!
- Turn on the barcode reader by pressing the trigger until you hear a long beep
To turn off the barcode reader, you must perform the same operation until you hear 2 beep - Set the barcode scanner by scanning the barcodes of the document available HERE
- Turn off the barcode reader and then turn it on
- Go to the Android Bluetooth settings and turn on the Bluetooth
- Search for your device from the Bluetooth settings on your Android tablet or POS
- Select the device named CT10XXXXXXXX and enter the pin code 10010
You barcode reader emits a beep which means that the pairing went well - Then, go to General > Language and Input
– Android 4.4 KitKat : on Keyboards and Input modes > By default, tick No for physical keyboard
– Android 5.0 Lollipop : on Keyboards and Input modes > By default, tick Use the keyboard on screen - Finally, by selecting the barcode reader in the physical keyboard, select the French keyboard
Your Bluetooth barcode reader is now configured and ready for use.